- Hello
I am facing a simple but odd question in using OrCAD Capture 17.4.
I have inserted into the schematics some test points in order to identify them when I will have the PCB.
It happens that the nets where the TP are inserted change their name with respect to the alias I imposed.
As an example, net labeled with alias CMD_L2 becomes CMD_L2_17233165. The alias anyway does NOT change!
I tried to change net name in properties or to delete the alias and place it again into the same position, without success.
I have found no property in the test point part which I can relate to such a behaviour.
Usually, posts that I found on TPs are about PCB layout, not about the schematics.
Could anyone be so kind to give me a piece of advice about how to solve this issue?
